I’m pretty new to this. I was considering replacing it with something else because it leaks slightly from the valve if it gets moved around at all, but I don’t know what this connection is to start with. It goes to a dishwasher.
Unfortunately is has stopped leaking for now. I say unfortunately, because I don’t know when it may start again. It seemed to start to leak when I pulled out the dishwasher, so movement/flexing/etc made it happen. I was unable to determine exactly where it leaked from, but it seemed to pool near the center of the entire valve, so it could have been near the crimped area or the knob area, or maybe even the connection going off to the dishwasher, and the water could have just run down to the lowest bit of the valve.
It’s 1/2" nominal PEX going to a quarter-turn shutoff, to a 3/8 braided dishwasher line. I just didn’t know what to call the weird crimped/connector part on the PEX, and thus how to properly remove it if necessary. All of the PEX crimps that I’ve found online have been very different looking.
The house was built 7 years ago, so maybe the plumbers just threw on whatever they had in their van. Do you know what the crimped method/area is called on this thing? Is there a specific term for it?
Thought I’d be alone to admitting using Hitachi/Metabo HPT. They kinda suck but get light duty stuff done and they don’t cost much, especially if you buy gray market versions.
What kind of valve is this exactly? Never seen that exact connection type ( lemmy.ml )
I’m pretty new to this. I was considering replacing it with something else because it leaks slightly from the valve if it gets moved around at all, but I don’t know what this connection is to start with. It goes to a dishwasher.
What brand of tools is everyone here using? ( lemmy.world )