Home Improvement

Is this wiring run ok? ( lemmy.world )

Finagled my way into the attic to explore a bit. Found this wiring run that basically lays on the sheet rock with insulation sitting on top. It goes to a light switch that controls three of this thin led recessed lights. Could this get really hot and start a fire with the insulation on top?...

Help repairing crumbling steps ( lemmy.world )

I’m not sure what material or style these steps are, but they’ve started crumbling after water got into a crack and froze during the winter. It seems to be getting worse and I’m wondering how to address it. Is this something that can be patched or do I need to remove all this material and start over?

Does anyone have experience with these triple filter reverse osmosis units? ( lemmy.world )

It’s leaking right where the arrow is pointing. It only leaks when it’s refilling the tank after each use. The two outside carbon filters were new in March but the middle (reverse osmosis) filter is probably a year or more older. I’m hoping it just needs a new RO filter and that it’s only leaking because it’s clogged....

Fixable or new water heater needed? ( lemmy.world )

Hot water was running out very quickly. I tested voltages, upper element looked good, on the lower the small protective plastic cover over the wires shocked me. I cut the breaker and found this loose wire. And obviously all this rust/mineral build up. If I were to fix I’d try to replace the element but I’m afraid that I...

Stripped Screw Hole in Ceiling Advice ( i.imgur.com )

I was hanging a ceiling fan in this room when I discovered that the mounting screw holes in the electrical box are stripped. My dad has suggested using JB Weld putty, letting it cure, drilling it out with a small bit and then using wood screws. First time homeowner and have neither the confidence nor the expertise to completely...

Stripped Screw Hole in Ceiling Advice ( i.imgur.com )

I was hanging a ceiling fan in this room when I discovered that the mounting screw holes in the electrical box are stripped. My dad has suggested using JB Weld putty, letting it cure, drilling it out with a small bit and then using wood screws. I’m a first time homeowner and have neither the confidence nor the expertise to...

  • All
  • Subscribed
  • Moderated
  • Favorites
  • random
  • [email protected]
  • All magazines