NarrativeBear

@[email protected]

This profile is from a federated server and may be incomplete. View on remote instance

NarrativeBear ,

Take off the drawer handle (the two screws), this will release the wood drawer front from the drawer face plate.

Once you have this wood you can fix it back to your drawer with a L- bracket. If the wood is broken too much on the side, you can replace this part with a piece equal in size and depth.

Like others suggested, pull the nails out and then add your new drawer front, nail it back in (or use screws, pre-drilling your screw holes). Then put your face plate back on.

NarrativeBear ,

You can cut them with a multi tool if you have one, no harm in that. You essentially just need them out of the way so you can put new nails.

A flush cutter is a good idea as well.

Help: TrueNAS upgrade, Seagate Exos "shudder" sounds.

I just finished the process of adding 8 new Seagate Exos 20TB drives to my TrueNAS core system. This question has been asked a lot and it’s known seagate drives are loader then most durring operation. Though i could not find anything related to a consistent “shudder” through all my new Exos drives. I have attached a audio...

NarrativeBear OP ,

Hi thanks for the reply, doing a extended smart test in TrueNAS now for all the hr disks.

The shudder is coming from all the Seagate drivers instantaneously as if they are cycling or something. Going to check if the noise stops once the system goes ideal after the smart test.

Any chance you can point me to how I could check regarding a firmware upgrade, I assume I would need to pull each drive and upgrade, or could I do this within TrueNAS.

NarrativeBear ,

Insect screen kits is what you might be looking for. I am guessing there may have been a screen net in this plastic frame at some point. You can always buy the net separately, but not 100% sure about the frame it’s self.

  • All
  • Subscribed
  • Moderated
  • Favorites
  • •
  • random
  • All magazines
    •